Have anyone use KT200 done DCU102 by OBD?
Have anyone use KT200 ecu programmer done DCU102 by OBD? Obd2gate.com engineer Answer: Only over boot mode, 2 pins on board. https://www.obd2gate.com/
ECUHELP KT200 ECU Tuner
ECUHELP KT200 is same to FoxFlash or similar?
ECUHELP KT200 is same to FoxFlash or similar? They are similar tools, FoxFlash cloned the first batch of KT200, you will find that foxflash has yellow adapter, and KT200 has already eliminated the first batch, and there is no need… Continue Reading
ECUHELP KT200 read write EDC17CP45 successfully
ECUHELP KT200 ECU Programmer successfully bench read and write EDC17CP45 BMW 3.0 280kw. And Bosch EDC17 CP45 – TC1797 (Bench Tricore)
ECUHELP KT200 troubleshooting
Question on ECUHELP KT200 ecu programmer VW/Audi with data stored in OTP data area. Looks like there’s an update on the software about reading OTP, how to successfully clone on these ecu’s and cart start? without having to mod files, keeping… Continue Reading
How to fix ECUHELP KT200 “Turn the dashboard off and back on…”?
KT200 error “Turn the dashboard off and back on, then wait for 10 sec before continue”. Look at the images below. Solution: Starting from where I started the GREEN ARROW. it’s the 12th pin and not the 11th where you… Continue Reading
ECUHELP KT200 Siemens SIM2K-140 141 341 D160 Boot Pinout
KT200 ECU Programmer Siemens SIM2K-140/141/341/D160 on the desktop (large connector) : 1,3,5 – ECU Ground (just connect one of the contacts) 77 – CAN-High 78 – CAN-Low 76 – K-Line 2 – + 12V (ignition on) 4 – + 12V (main… Continue Reading
ECUHELP KT200 ECU Programmer Feedback
ECUHELP KT200 ECU programmer can perform ECU maintenance chip tuning, DTC code removal, OBD/BOOT/BDM/JTAG, and multiple protocols. And it is the Master version, means it can read and write ECU data, read it in BIN unencrypted format, allows you to modify… Continue Reading
Way of ECUHELP KT200 clone DCM6.2C PSA in boot & JTAG mode
ECUHELP KT200 ECU Programmer can clone DCM6.2C PSA, it reads and writes Flash+EEprom in BOOT mode and JTAG , if you have org AUTOTUNER you will find it reads FLASH+EEprom but writes only FLASH. How to use KT200 clone DCM6.2C PSA in boot & JTAG mode?… Continue Reading
ECUHELP KT200 BOSCH MD1CS018 pinout and video
ECUHELP KT200 ecu programmer can read and write BOSCH MD1CS018 ECM without any errors, the operation way is as the same as mg1cs026. MD1CS018 pinout Read the follow youtube video for operation steps: https://www.youtube.com/watch?v=8p-L_yjOQ6I www.obd2gate.com
Way of ECUHELP KT200 read Ems3155 in boot mode
ECUHELP KT200 ECU programmer is confirmed to read and write Ems3155 in boot mode, that means it needs to dismantle the ECU. Look at the pinout below: Hope it helps!
