Autel IM608 Pro 2 key programmer can program remotes for the 2018 HONDA Civic without any issues. Here are the instructions on how to perform this task.
Procedure:
Start by launching Autel IM608 pro ii and accessing the IMMO section.
Agree to the disclaimer to proceed.
Follow the path:
Choose “Honda” from the options
Then select “manual selection”
Next, select “Civic” followed by “Touch tone smart card”
Initiate an IMMO status scan to check the vehicle’s current status.
Press the start button twice to turn the ignition on.
Ensure there are no faults reported.
Initiate Key Addition with IM608 2
Turn off the ignition (pressing the engine start/stop button instead of pressing the foot brake).
Please allow the ECU to stabilize.
Take out any other keyless access remotes from the vehicle.
Place the registered keyless access remote into the vehicle.
Ignition On and Checking:
Turn the ignition switch on (press the engine start/stop button twice without pressing the foot brake).
Check the vehicle’s condition.
Remove all original keyless access remotes from the vehicle.
Place the new keyless access remote inside the vehicle.
IM608 II will notify you that the new keyless access remote has been successfully registered.
Turn off the ignition (press the engine start/stop button without pressing the foot brake).
Wait for the ECU to stabilize.
Turn the ignition on again (press the engine start/stop button without pressing the foot brake).
Are both the keyless access and immobilizer indicator lights turned off?
Turn off the ignition once more (press the engine start/stop button without pressing the foot brake)
Wait for the ECU to stabilize.
Turn the ignition switch on (press the engine start/stop button without pressing the foot brake).
Finalize the registration process.
Turn off the ignition (press the engine start/stop button without pressing the foot brake).
Allow for the ECU to stabilize.
Verify that all keyless access remotes can initiate engine ignition.
Ensure that each keyless access remote can reliably lock and unlock the doors.
Turn the ignition switch on (without pressing the foot brake, press the engine start/stop button twice).
IMMO status scanning
The remote programming process is now successfully done.
By following these steps, you can efficiently program remotes for your 2018 HONDA Civic using Autel IM608 Pro II programmer.
